Gleaner R65/R66/R75/R76 And S Series Combines (Except S9 Series); Checking Voltage Range From Combine Cab (Gleaner R65/R66/R75/R76 And S Series) - MacDon FFT FD75 Assembly Instructions Manual

5.1.6 Gleaner R65/R66/R75/R76 and S Series Combines (Except S9 Series)

Checking Voltage Range from Combine Cab (Gleaner R65/R66/R75/R76 and S Series)

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
NOTE:
Refer to 5.1.7 Gleaner S9 Series Combines, page 179
1. Position header 150 mm (6 in.) above ground, and unlock CA25 float.
2. Check that float lock linkage is on down stops
(washer [A] and nut [B] cannot be moved) at both
locations.
NOTE:
If header is not on down stops during next two steps,
voltage may go out of range during operation causing a
malfunction of auto header height control (AHHC)
system.
3. Ensure pointer (A) on float indicator box is on 0. If
necessary, adjust cable take-up bracket (B) until pointer
is on 0.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
for information specific to Gleaner S9 Series.
Figure 5.70: Float Lock
Figure 5.71: Float Indicator Box
170
Revision A