Calibrating Auto Header Height Control (Challenger 6 Series) - MacDon FFT FD75 Assembly Instructions Manual

Calibrating Auto Header Height Control (Challenger 6 Series)

NOTE:
For best performance of auto header height control (AHHC) system, perform these procedures with center-link set
to D. When setup and calibration are complete, adjust center-link back to desired header angle. Refer to Header
Angle in header operator's manual.
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Ensure center-link is set to D.
2. On FIELD page, press DIAGNOSTICS icon. The
MISCELLANEOUS page appears.
3. Press CALIBRATIONS button. The CALIBRATIONS
page appears.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.53: Challenger Combine Display
Figure 5.54: Challenger Combine Display
162
Revision A