Chapter 4: Performing Predelivery Checks; Checking Transport/Stabilizer Tire Pressure - MacDon FFT FD75 Assembly Instructions Manual

4 Performing Predelivery Checks
This machine has been set at the factory and should not require further adjustments; however, the following checks
will ensure your machine provides maximum performance. If adjustments are necessary, follow the procedures in
this chapter.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
IMPORTANT:
To avoid machine damage, check that no shipping material has fallen into machine.
1. Perform final checks as listed on Predelivery Checklist (yellow sheet attached to this instruction – ) to ensure
machine is field-ready. Refer to following pages for detailed instructions as indicated on Checklist. The
completed Checklist should be retained either by Operator or Dealer.

4.1 Checking Transport/Stabilizer Tire Pressure

Check tire inflation pressure. If necessary, adjust pressure according to following table:
Table 4.1 Tire Inflation Pressure
Size
ST205/75 R15
IMPORTANT:
Do NOT exceed maximum pressure specified on tire sidewall.
214325
Load Range
D
E
89
Pressure
448 kPa (65 psi)
552 kPa (80 psi)
Revision A