Table of Contents
Advertisement
4. On combine, ensure lock handle (A) is positioned so
hooks (B) can engage adapter.
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
5. Start engine and slowly drive combine up to header
until feeder house saddle (A) is directly under adapter
top cross member (B).
6. Raise feeder house slightly to lift header, ensuring
feeder saddle is properly engaged in adapter frame.
7. Stop engine and remove key from ignition.
8. On left of feeder house, lift lever (A) on adapter and
push handle (B) on combine to engage locks (C) on
both sides of feeder house.
9. Push down on lever (A) so slot in lever engages handle
and locks handle in place.
10. If lock (C) does not fully engage pin on adapter, loosen
bolts (D) and adjust lock. Retighten bolts.
214325
ASSEMBLING HEADER AND ADAPTER
36
Figure 3.46: Feeder House Lock
Figure 3.47: Combine and Adapter
Figure 3.48: Combine and Adapter
Revision A
Hide quick links:
Advertisement
Table of Contents
