Table of Contents
Advertisement
3.4.8 Installing Crop Dividers with Latch Option
1. If not already open, open endshields. Refer to
Opening Endshield, page
2. Position crop divider as shown by inserting lugs (A) into
holes in endsheet.
3. Lift forward end of divider until pin (B) engages and
closes latch (C).
4. Push safety lever (D) down to lock pin in latch.
5. Check that divider does not move laterally. Adjust
bolts (A) as required to tighten divider and remove
lateral play when pulling at divider tip.
6. Close endshield. Refer to
page
87.
214325
ASSEMBLING HEADER AND ADAPTER
3.4.5
83.
3.4.9 Closing Endshield,
Figure 3.169: Crop Divider Installation
Figure 3.170: Crop Divider Adjustment
86
Revision A
Hide quick links:
Advertisement
Table of Contents
