Table of Contents
Advertisement
1. Remove two bolts (A) and remove strap (B) from both
sides of center frame.
NOTE:
If strap is difficult to remove, lift on one end of header to
release load on strap so that bolts can be removed.
2. Remove lynch pin (A), nut and bolt (B), and remove
shipping brace (C).
3. Reinstall lynch pin (A).
3.4.4 Positioning Transport Lights
Transport lights are located on each outboard reel arm.
1. Position light (A) perpendicular to header. Light arm
should move with normal hand force yet maintain its
position. If not, proceed to next step.
2. Loosen jam nut (B) on light attachment bolt, and adjust
hex nut (C) as required. Tighten jam nut (B).
3. Repeat above for opposite side.
214325
ASSEMBLING HEADER AND ADAPTER
82
Figure 3.159: Strap on Center Frame
Figure 3.160: Shipping Brace
Figure 3.161: Transport Light
Revision A
Hide quick links:
Advertisement
Table of Contents
