Table of Contents
Advertisement
2. Adjust center arm lift cylinder link (A) to set clearance at
center of reel and clearance at flex points as follows:
a. Loosen nut (B).
b. Turn nut (C) counterclockwise to raise reel and
increase clearance to cutterbar, or clockwise to
lower reel and decrease clearance.
c. Tighten nut (B).
3. Move reel back to ensure steel end fingers do not contact deflector shields.
4. If contact is evident, adjust reel upward to maintain clearance at all reel fore/aft positions. Alternatively, trim
steel end fingers to obtain proper clearance.
5. Periodically check for evidence of contact, and adjust clearance as required.
4.9.3 Checking and Adjusting Reel Cam
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Ensure reel cam latch pin (A) is in the same cam
position (B) at both the center cam disc and right cam
disc (not shown) . If latch pin position is not the same on
both cams, proceed to Step
cam position.
214325
PERFORMING PREDELIVERY CHECKS
2, page 102
to adjust reel
101
Figure 4.22: Center Arm
Figure 4.23: Cam Disc Center Reel Arm
Revision A
Hide quick links:
Advertisement
Table of Contents
