2. Loosen nut (A) and move bolt out of shipping
position slot.
3. Rotate gearbox and insert bolt into working position
slot (A). Tighten nut.
4. Remove bolt and nut from bracket on gearbox.
5. Position brace (A) inside bracket, and reinstall bolt (B)
and nut.
3.4.3 Removing Shipping Supports
The shipping supports are painted yellow, remove supports as follows:
NOTE:
Unless otherwise specified, discard supports as well as all shipping material and hardware.
214325
ASSEMBLING HEADER AND ADAPTER
81
Figure 3.156: Shipping Position
Figure 3.157: Working Position
Figure 3.158: Brace Position
Revision A