Table of Contents
Advertisement
5. Pull handle (A) on adapter to release multicoupler (B)
from storage position. Remove multicoupler, and push
handle back into adapter to store.
6. Position multicoupler (A) onto receptacle, and pull
handle (B) to engage lugs on multicoupler into
the handle.
7. Pull handle (B) to a horizontal position and ensure
multicoupler (A) is fully engaged into receptacle.
8. Ensure that both feeder house pins (C) are fully
engaged into adapter brackets.
NOTE:
If pins (C) do not fully engage adapter brackets, loosen
bolts (D) and adjust bracket as required.
9. Tighten bolts (D).
214325
ASSEMBLING HEADER AND ADAPTER
50
Figure 3.79: Multicoupler Storage
Figure 3.80: Multicoupler
Figure 3.81: Feeder House Pin
Revision A
Hide quick links:
Advertisement
Table of Contents
