Table of Contents
Advertisement
3. Remove top gasket (A) for use in next step.
NOTE:
There are two gaskets—one on either side of filler
strainer flange.
4. Place gasket (A) (removed from top of filler strainer)
onto filler cap neck (B), and align holes.
5. Install flange head screws supplied in bag (refer to Step
1, page
21) onto filler cap neck (B), pressing screws
through gasket (A).
®
6. Apply Loctite
#565 (or equivalent) to screws.
7. Place filler cap neck (A) (complete with screws) over
opening. Ensure machine screws are aligned with
threaded holes.
8. Carefully thread in machine screws according to
numbered sequence as shown to prevent cross
threading.
9. Torque screws to 3.5 Nm (31 lbf·in) according to
numbered sequence.
214325
ASSEMBLING HEADER AND ADAPTER
22
Figure 3.15: Top Gasket
Figure 3.16: Filler Cap Neck
Figure 3.17: Screw Hole Locations
Revision A
Hide quick links:
Advertisement
Table of Contents
