Chapter 3: Assembling The Header; Removing Underside Shipping Support And Installing Auger Pan - MacDon R85 Assembly Instructions Manual

3 Assembling the Header
3.1 Removing Underside Shipping Support and Installing
Auger Pan
CAUTION
Keep feet clear when removing final bolts.
1. Use a forklift to support stand.
2. Remove two bolts (A) on each end of support and
remove shipping support (B). Lay support on ground.
3. Cut banding (A), and remove auger pan (B) and
hardware from stand. Discard stand.
4. Locate the hardware bag strapped between auger
pan (B) and the stand.
214367
Figure 3.1: Shipping Support
A
Figure 3.2: Auger Pan Attached to
Shipping Support
7
A
B
B
Revision A