Chapter 3: Assembling Header; Attaching Reel Lift Cylinders - MacDon D65 Assembly Instruction Manual

3 Assembling Header
Perform all procedures in the order they are listed.

3.1 Attaching Reel Lift Cylinders

Unless otherwise stated, the following procedure applies to single- and double-reel headers.
1. Remove two top bolts (A) on outboard reel arm
supports. Repeat for opposite side.
2. Double-reel headers: Remove two top bolts (A) on
center reel arm to allow center reel arm to move.
214328
Figure 3.1: Reel Outboard Support Arm
Figure 3.2: Reel Center Arm: Double-Reel
Header
17
Revision A