Setting A Remote Interface Into Loopback Mode - Juniper EX9200 Features Manual

Related
Documentation

Setting a Remote Interface into Loopback Mode

Copyright © 2016, Juniper Networks, Inc.
To apply an action profile to an interface, include the
the
[edit protocols oam ethernet link-fault-management action-profile interface
interface-name] hierarchy level:
[edit protocol oam ethernet link-fault-management interface interface-name]
apply-action-profile profile-name;
apply-action-profile on page 48
IEEE 802.3ah OAM Link-Fault Management Overview on page 3
Configuring IEEE 802.3ah OAM Link-Fault Management on page 5
Enabling IEEE 802.3ah OAM Support on page 6
Configuring Link Discovery on page 16
Configuring the OAM PDU Interval on page 6
Configuring the OAM PDU Threshold on page 7
Configuring Threshold Values for Local Fault Events on an Interface on page 17
Disabling the Sending of Link Event TLVs on page 18
Detecting Remote Faults on page 18
Configuring an OAM Action Profile on page 8
Specifying the Actions to Be Taken for Link-Fault Management Events on page 19
Monitoring the Loss of Link Adjacency on page 12
Monitoring Protocol Status on page 13
Configuring Threshold Values for Fault Events in an Action Profile on page 10
Setting a Remote Interface into Loopback Mode on page 11
Enabling Remote Loopback Support on the Local Interface on page 15
Example: Configuring IEEE 802.3ah OAM Support on an Interface on page 21
Ethernet Interfaces Feature Guide for Routing Devices
You can configure the software to set the remote DTE into loopback mode on the
following interfaces:
IQ2 and IQ2-E Gigabit Ethernet interfaces
Ethernet interfaces on the MX Series routers or EX Series switches
Junos OS can place a remote DTE into loopback mode (if remote-loopback mode is
supported by the remote DTE). When you place a remote DTE into loopback mode, the
interface receives the remote-loopback request and puts the interface into
remote-loopback mode. When the interface is in remote-loopback mode, all frames
Chapter 1: Configuring Ethernet OAM Link Fault Management
apply-action-profile
statement at
11