Check the LEDs on the craft interface to verify the hardware status after reinstalling or powering on the
MX2010 router.
For a list of system status verification commands, see the
Guide
at
https:/
/www.juniper.net/documentation/.
To configure the software:
Enter Configuration Mode
1. Verify that the network device is powered on.
2. Log in as the root user. There is no password.
Amnesiac <ttyd0>
login: root
3. Start the CLI.
root@% cli
root>
4. Enter configuration mode.
root> configure
Entering configuration mode.
[edit]
root#
Configure User Accounts and Passwords
For information about using an encrypted password or an SSH public key string (DSA or RSA), see
authentication.
MX2010 Universal Routing Platform Hardware
78