Before You Begin; Connecting The Usb Modem To The Services Router's Usb Port; Configuring Usb Modem Interfaces With A Configuration Editor; Configuring A Usb Modem Interface (Required) - Juniper J-Series Administration Manual

Juniper networks router administration guide
Hide thumbs Also See for J-Series:
Table of Contents

Advertisement

Before You Begin

Before you configure USB modems, you need to perform the following tasks:

Connecting the USB Modem to the Services Router's USB Port

NOTE: J4350 and J6350 Services Routers have two USB ports. However, you can
connect only one USB modem to the USB ports on these routers. If you connect USB
modems to both ports, the router detects only the first modem connected.
To connect the USB modem to the USB port on the router:
1.
2.

Configuring USB Modem Interfaces with a Configuration Editor

To configure USB modem interfaces, perform the following tasks marked (Required).
Perform other tasks if needed on your network.

Configuring a USB Modem Interface (Required)

To configure a USB modem interface for the Services Router:
Install Services Router hardware. For more information, see the Getting Started
Guide for your router.
Establish basic connectivity. For more information, see the Getting Started Guide
for your router.
Order a Multi-Tech MultiModem MT5634ZBA-USB-V92 USB modem from
Multi-Tech Systems (
http://www.multitech.com/
Order a dial-up modem for the PC or laptop computer at the remote location
from where you want to connect to the Services Router.
Order a public switched telephone network (PSTN) line from your
telecommunications service provider. Contact your service provider for more
information.
If you do not already have a basic understanding of physical and logical interfaces
and Juniper Networks interface conventions, see the J-series Services Router Basic
LAN and WAN Access Configuration Guide.
Plug the modem into the USB port.
Connect the modem to your telephone network.
Configuring a USB Modem Interface (Required) on page 33
Configuring a Dialer Interface (Required) on page 35
Configuring Dial-In (Required) on page 36
Configuring CHAP on Dialer Interfaces (Optional) on page 37
Chapter 2: Setting Up USB Modems for Remote Management
).
33

Before You Begin

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents