Rcm-26 User Controls - Bosch IRIS-Net User Manual

IRIS-Net
ShelvingEQ_Freq_Gain_02
System_Supervision_01

RCM-26 User Controls

Following sets of connections are used in following table:
– RCM-26-Amp: TG-5, TG-7, H2500, H5000
– RCM-26-Amp-Channel: TG-5.ChA, TG-5.ChB, TG-7.ChA, TG-7.ChB, H2500.ChA, H2500.ChB, H5000.ChA, H5000.ChB
Picture
Bosch Security Systems B.V.
Equalizer panel with label field for the RCM-24 Remote Amp.
Pre-set for band 5 of the channel equalizer. Equalizer type,
frequency, gain and BYPASS can be set. Possible
Connections: RCM- 24-Amp.
The amplifier LED lights red when in Standby or Protection
mode. Otherwise, the LED lights green. The speaker LED
lights red at the occurrence of the load at the amplifier's
output going outside the range set by the minimum and
maximum impedance values (a open or shorted line).
Otherwise, the LED lights green. Possible Connections:
RCM-24-Amp.
Name
PowerH_Panel_01
PowerH_Panel_02
RCM-26_Group_Panel_0
1
User Manual
Description
In Online mode the LED light green. Otherwise, the LED
light red. The LEDs below the CAN address field light
green / yellow when the amplifiers is Power / Standby
mode. ON button for switching the amp's power on or
off. Possible Connections: RCM-26-Amp.
In Online mode the LED light green. Otherwise, the LED
light red. The LEDs below the CAN address field light
green / yellow when the amplifiers is Power / Standby
mode. ON button for switching the amp's power on or
off. Additionally two LEDs for VU data of amplifier
inputs. Possible Connections: RCM-26-Amp.
These three LEDs indicate clipping (CLIP) or whether
the limiter (LIMIT) or the compressor (COMP) of the
DSP is active. Fader and MUTE buttons for cont- rolling
and LED bar graph meter for monitoring the amp's
output channel. Clicking onto the "0" marking resets the
fader to 0 dB. Possible Connections: RCM-26-Amp-
Channel.
IRIS-Net | en 28
2017.05 | 3.20 | F.01U.119.956