Bosch IRIS-Net User Manual page 958

IRIS-Net
OPERATION MODE
The "PVACON_1.System.PowerManagement.OperatingMode" property allows setting the current operation mode of the
PVA-4CR12 and connected devices. High priority signals prevent changing into standby mode. Following settings are
available:
Value
0
1
HINT: The mode of peripheral devices connected to the PVA-4CR12 is set automatically.
STANDBYLED
The Standby LED of the PVA-4CR12 lights, when the device is in standby mode. The corresponding property
"PVACON_1.System.Info.StandbyLED" can be used to query the current mode.
Value
0
1
AudioNet Dialog
The AudioNet dialog allows the configuration and supervision of an audio network, consisting of two or more PAVIRO
controllers connected via an OM-1 module. The AudioNet tab will only be displayed when more than 1 controller is
added in the network. With AudioNet it is possible to transmit audio signals from one PAVIRO controller to another.
One controller needs to be configured as AudioNet master. PVACON_1 will be the master by default. All other PAVIRO
controllers within the project are automatically configured as AudioNet slave. Both OM-1 interface (audio) and Ethernet
(control data) are required for setting up an AudioNet. Upon failure of the primary interface, the secondary interface
will be activated automatically. In case of failure of the Ethernet, AudioNet Redundancy is enabled. This function allows
transmitting a signal in a predefined zone pattern to all PAVIRO controllers, if the function is activated and a
Destination is defined.
Bosch Security Systems B.V.
Description
Switch PVA-4CR12 in standby mode
Switch PVA-4CR12 in operating mode
Description
PVA-4CR12 is in operating mode
PVA-4CR12 is in standby mode
User Manual
PAVIRO | en 958
2017.05 | 3.20 | F.01U.119.956