Amplifier Setup; Digital Input - Bosch IRIS-Net User Manual

IRIS-Net

Amplifier Setup

Element Default
GAIN/
SENSITIVITY
POWER DELAY Address *
150 ms
BREAKER
INPUT SELECT

Digital Input

Element Default
SAMPLE RATE 96 kHz
Auto Switch
Enable
Bosch Security Systems B.V.
Range Description
GAIN/SENSITIVITY displays the amplifiers constant gain of +35 dB.
50...4000 ms Allows programming an amplifier's power-on delay. Setting different
50 ms Steps delay times is recommended to prevent the mains fuse from blowing
when powering on several amps at the same time.
Show the current setting of the amplifier's Mains Circuit Breaker
Protection. For further details about this protection please refer to
the owner's manual.
Allow selecting the audio input. The analog audio input (ANALOG) or
the digital audio input (AES/ EBU) are available.
HINT: The value of the property "Audio Input" corresponds to the
currently used audio input. You can write the value "ANLG" to this
property to select the analog audio input. You can write the value
"AES" to this property to select the digital audio input.
Range Description
Indicates if the digital audio input is synchronized to the input signal
(LOCKED LED on) or if synchronization was not successful (ERROR-
LED off).
HINT: The current state of the digital audio input is available via the
property "StateFlags. AES Locked" also.
32...129 Shows the sample rate of the digital input signal.
kHz
Activate this control if the audio input should switch from digital
input to analog input automatically if the digital input signal is not
OK.
HINT: The value of the property "Audio Input Switching. AES Fail.
Enable" corresponds to this control.
User Manual
REMOTE AMPLIFIER | en
2017.05 | 3.20 | F.01U.119.956
183