Bosch IRIS-Net User Manual page 944

IRIS-Net
FILTER and trigger list
PAGING
EXISTING
NEW/UPDATE
TYPE
LABEL
PRIORITY
ALARM
PRECHIME TYPE
CHIME TYPE
MESSAGE NR
INPUT CHANNEL
DESTINATIONS
STATIC
DYNAMIC
Keywords in condition list
Keywords can be selected from the condition list to start a signal:
Pagings.VCondition%d.Value where %d is replaced with an ongoing decimal number.
The "V" is short for "Virtual"", so this keyword can be considered as a "Virtual condition" to start a signal. The keyword
can be referenced by a Logical Key on a call station and allows to directly control a signal trigger without redirection
via the Task Engine. Thus, it is no longer required to create a V-LOGIC block in the Task Engine which is then used as a
condition in the Pagings dialog.
Logical keys can be explicitly used for Alarm Buttons on a Call Station.
See also Logical Key, page 974.
See also
– Configuration Dialog, page 974
– Pagings Dialog, page 765
– Pagings Dialog, page 766
Programs Dialog
The Programs dialog allows to configure 4 programs for background music.
Bosch Security Systems B.V.
Select the trigger condition from the list. Enter a string (e.g. GPI) in the text field
FILTER to list only the conditions containing this string.
Select EXISTING to select an existing paging from the dropdown menu.
Select NEW/UPDATE to edit the settings of the paging.
Select the paging type from the dropdown.
Enter the name of the paging.
Select the priority of the paging.
If the selected paging TYPE = ALARM you can select the alarm type from this
dropdown.
If the selected paging TYPE = ANNOUNCEMENT you can select the pre-chime
type from this dropdown.
If the selected paging TYPE = CHIME you can select the chime type from this
dropdown.
If the selected paging TYPE = EVAC Message you can select the message number
from this dropdown.
If the selected paging TYPE= ANNOUNCEMENT or TYPE = ALARM (and ALARM =
Extern) you can select the audio input channel for the paging.
Select the zones or groups of the paging.
Select a STATIC destination zone pattern for a CONDITION.
When selecting a DYNAMIC destination zone pattern, it is only possible to select
one Call Station from the list (no multi selection). For DYNAMIC destinations, the
current selection of the referenced Call Station is used to start the signal when
the condition reaches the state "high" (for a high priority signal).
See Dynamic Destination behavior on a Call Station, page 766.
User Manual
PAVIRO | en 944
2017.05 | 3.20 | F.01U.119.956