Bosch IRIS-Net User Manual page 110

IRIS-Net
These buttons allow assigning amplifier channels to the monitor bus. The monitor bus allows
monitoring any amplifier input or output signals within an installation. INPUT A / B selects the
corresponding input signal while OUTPUT A / B allows switching between the output signals of
channels A and B. Simply click on an amp channel's icon to select it for monitoring. The
corresponding channel is assigned to the monitor bus. Any previous selection is simultaneously
canceled, so that only the actually selected amp channel can be monitored. Clicking the button of
an active amp channel separates the channel from the monitor bus.
This field indicates the active factory or user preset. Each remote amp has a factory setting F01
offering linear settings and eight user-programmable presets U0...U08 for storing random user data.
Loading and saving presets is done in the Setup & Control window.
Clicking on the SET button opens the Setup & Control Window, which provides access to all
amplifier- and DSP-parameters, control and monitoring functions plus additional function groups.
This soft-key allows switching an amplifier on or off. The STANDBY and POWER indicators signal the
actual operational status. The Config & Info window allows programming individual power-on delays
for each amplifier.
Note: The power-on delay defaults to „Address * 150 ms". For address 8 the power-on delay default
would be for example: 8 * 150 ms = 1200 ms.
These indicators show the amp's actual operational status. STANDBY lights whenever the amplifier
is in stand-by mode. POWER lights whenever the amplifier is powered-on and ready for operation. If
neither one of the indicators lights, the amplifier is either off-line or powered-off.
Bosch Security Systems B.V. User Manual
REMOTE AMPLIFIER | en
2017.05 | 3.20 | F.01U.119.956
110