Bosch IRIS-Net User Manual page 317

IRIS-Net
INFO
SET
SYNC
DSP Dialog
The DSP window lets the user configure all DSP functions of the NetMax N8000. This is possible by selecting DSP-
Blocks of the Processing Objects categories on the left side of the screen and dragging them into the DSP worksheet.
DSP- Blocks can be freely positioned and wired within the worksheet. Double clicking on a DSP-Block's icon allows
editing its configuration and settings in detail.
Bosch Security Systems B.V.
This view represents the rear panel of a N8000 with module slots
and extension cards. In off-line mode, clicking onto the slots with
the right mouse button and by exchanging, adding or deleting
extension cards, allows defining the unit's configuration. When on-
line, the display shows the actually installed extension cards.
Differences from the off-line configuration are recognized and
marked in yellow or red.
HINT: A yellow indicator signals that the hardware equipment
differs from the software configuration. However, this difference
does not cause any problems during on-line operation. A red
indicator signals an existing conflict between hardware and
software configurations, which needs to be remedied, either by
customizing the N8000's hardware equipment or through
modifying the software configuration.
Indicates the IP address of the N8000's Ethernet port (factory
setting: 192.168.1.100). Enter the address of the N8000 with which
you want to establish on-line communication.
Indicates the Ethernet port's network mask (factory setting:
255.255.255.0).
Indicates the standard gateway of the Ethernet port (factory setting:
192.168.1.1).
Indicates the MAC address of the connected N8000 when on-line.
The MAC address of the N8000 is also shown on a label on the unit's
rear panel.
IRIS-Net internal device name of the N8000.
IRIS-Net project filename.
This button displays information concerning the IRIS-Net project file.
Date and time of the N8000 system clock.
This button opens the system clock settings dialog box.
This button syncs the N8000 system clock to the PC system clock.
Indicates the firmware version of the N8000 when on-line.
Reboots the N8000.
User Manual
DIGITAL MATRIX | en 317
2017.05 | 3.20 | F.01U.119.956