Table of Contents
Advertisement
Installation Instructions
Starting Up the SmartKey Code Keypad with Reader
(or changing user codes)
Notes on operation
The user code for the NZ 300 LSN and "integrated" SmartKey is described in detail in the
-
NzPara online help under "User Codes" (different default setting).
Define your user code during the first start-up. User codes can always be changed at a later
-
date. Both operational procedures are identical.
-
User codes always have 6 digits, the default code is 000000.
The user code can only be changed when the system is disarmed. The system cannot be ar-
-
med while a user code is being changed.
Code entry can be aborted by pressing the "C" key. The buzzer sounds intermittent tones for
-
6 seconds. The LEDs on the reader are deactivated.
If the user code is entered incorrectly three times, a wait period of 5 minutes begins. The buz-
-
zer sounds intermittent tones for 6 seconds. The LEDs are deactivated. If another incorrect
entry is made, another waiting period of 5 minutes follows.
Provided the yellow LED on the code keypad has been correctly programmed and connected
to the C-point of the control unit, a blocked code keypad or reader can be indicated during a
system status query (using code keypad or key) by the yellow LED, which lights up for ap-
proximately 5 seconds.
A maximum interval of 1 minute is permitted between each operational step when operating
-
the code keypad. The initiated operation will be aborted if no input is made during the 60-
second period.
-
The LEDs and the buzzer on the reader are used as signals when codes are changed.
Notes on the user code
The code keypad and reader can also be operated without a SmartKey. In this case,
enter the user number (ID) and user code to allow operation.
Continued overleaf.
General information: The code keypad, used in conjunc-
tion with the reader, allows the intrusion alarm system to be
armed and disarm only after the correct combination of num-
bers has been entered on the keypad. When arming and di-
sarming, the SmartKey is used first followed by the user co-
de.
Hold-up code: If someone is forced to disarm the intrusion
alarm system under duress, a silent alarm (hold-up alarm)
can be triggered via the code keypad by increasing the value
of the last digit of the user code; this is programmable be-
tween the values 1 and 9.
26
Advertisement
Table of Contents
