Firmware Upgrade - Bosch IRIS-Net User Manual

IRIS-Net
MEMFLAG
../PRM/MASK NONE, 1...16
../PRM/
VALUE
PRESET
../PRM/DIRTY ON, OFF
../PRM/USER NONE, 1...8
../PRM/FACT

Firmware Upgrade

The firmware of EV remote amps is stored in a FLASH-memory chip. This technology has been chosen to be able to pro-
vide the users with new software without the hassle of physically exchanging memory chips inside of a remote
amplifier. Using IRIS-Net, upgrading the firmware is possible via the CAN Remote Control Interface. In this way you can
install new firmware and future software extensions to always keep your EV Remote Amplifier System up-to-date.
Bosch Security Systems B.V.
PILOT_A, set, when pilot tone monitoring returns errors
PILOT_B
DIRTY set, when the actual preset has been edited but has not been saved yet
PWRGOOD set, when Power Good interpretation returns errors
CANPOLL set, when the CAN Polling timed out
BRIDGED set, when the power amp is operated in Bridged Mode (only with
P3000RL)
COLLECT set, when the amp's Collected Error Flag is ON
GLOBAL set, when the amp's External Amplifier Error Flag is ON
MEAS set, when the internal testing generator has been activated for output
load measurement
Z_VLD_A, set, when output load measuring is not possible because of missing or
Z_VLD_B too low signal
EEPROM set when there is an error in EEPROM administration
PRSGATE if not set, only limited preset changes are possible
PLT_IN_A, set, when the 19kHz pilot tone signal applied to the amplifier input is
PLT_IN_B not recognized
PLT_OUT_A, set, when the 19kHz pilot tone signal applied to the amplifier output is
PLT_OUT_B not recognized
Interpretation results in "true", when the actual state of the selected
memo flags resembles the reference pattern.
Selects memo flags to be interpreted (listing)
NONE, 1...16 Defines the expected reference pattern for memo flags
Interpretation results in "true", when the actual preset is identical to a
selected preset.
Selection is also valid, when parameters have been changed (dirty)
List of selected user presets
NONE, 1 List of selected factory presets
User Manual
REMOTE AMPLIFIER | en
2017.05 | 3.20 | F.01U.119.956
170