Bosch IRIS-Net User Manual page 713

IRIS-Net
Type of the selected PWS front user panel.
Number of the selected PWS front user panel. Front user panels are numbered in
ascending order if a wall station includes more than one panel of the same type.
Opens a dialog for printing out label field names.
Element
/
Bosch Security Systems B.V.
Description
Allows setting a CAN address and indicates the set CAN address. Left-click in
the entry field and enter the desired wall station address in the range between
1 and 250. Hit Return to accept the set address. The entered address and the
set- ting of the address selection switch on the PWS-C CAN Bus coupler have to
be identical and may exist only once on a specific CAN Bus. When adding new
wall stations to an IRIS-Net project, CAN addresses are automatically allocated
in ascending order.
Baud rate of the CAN-Bus to which the wall station is connected. Indication is
only provided when in on-line mode. For detailed information on setting the
correct baud rate of the System Controller or PWS-C CAN Bus coupler to be
cont- rolled, please refer to the according documentation.
Lets you select a control of the selected PWS front user panel. Selecting the
control directly via left-click in the GUI of the front user panel is possible as
well.
Lets you select the desired button type for the selected control. Controls can be
used as Action Button (execute action, e.g. .B. loading a preset)
Push Button (single push button), Radio Group (a variety of switches that
trigger each other – for switching different functions or parameters, e.g. source
selection),
Switch Button (switch – for switching between two states, e.g. muting) or
Channel Selection (only PWS-4, switching parameters edited by up/down
buttons).
Assign a name to the currently selected control.
The control's state when activated. Notes on how to manually assign parameter
values are provided in the ASCII Control Protocol documentation of the system
controller to be controlled.
The control's state when deactivated. Notes on how to manually assign
parameter values are provided in the ASCII Control Protocol documentation of
the system controller to be controlled.
Lets you select the action executed when using BUTTON TYPE Action Button.
PWS PROGRAMMABLE WALL STATION | en
User Manual
713
2017.05 | 3.20 | F.01U.119.956