Sony MVS-8000X User Manual page 1200

7
Setting the delay value
1
2
Setting the Re-entry Button Operation Mode
When you select a re-entry button in the cross-point control block of an M/E
block (downstream M/E block), the output of the upstream M/E block is read
in. You can set the system so that when a GPI link is set for the cross-point
selected on the A
In the Switcher >Link >GPI Link menu, set [Re-Entry Enable] to On or Off.
When this is On, the GPI is executed upstream.
a) When the bus toggle is set to Off, the applicable bus depends on the position of the fader lever.
Notes
• For re-entry, "upstream" applies to a single stage only.
• This setting is common to all GPI output ports.
• GPI output execution on the upstream M/E block is only possible on buses
• GPI output occurs when you press a re-entry button, the re-entry button is
1200
Settings Relating to Function Links (Link Menu)
Knob Parameter
4 Bus
In the <Bus> group, select any of the following.
Enable: Enable the GPI link setting for the selected bus.
Disable: Disable the GPI link setting for the selected bus.
All Enable: Enable the GPI link setting for all buses.
In the Switcher >Link >GPI Link Adjust menu, turn the knobs to select the
output port for which you want to set the delay value, and the
corresponding delay value.
Knob Parameter
1 GPI Port
5 Delay
Press [Delay Set].
This confirms the delay value, which is reflected in the status area.
a)
bus of the upstream M/E block this triggers the GPI output.
for which GPI Link is set to "Enable" in the GPI Link Adjust menu.
selected by a macro execution, or you press the re-entry button on the AUX
bus remote panel.
Adjustment
Bus selection
Adjustment
GPI output port for the
setting
Delay value for the output
port
Setting values
1 and upwards
Setting values
1 to 8
0 to 300 (fields)