Making Switcher Processor Gpi Input Settings - Sony MVS-8000X User Manual

Notes
When REMOTE3 and REMOTE4 are respectively assigned to DME1 and
DME2, you can switch the AUX bus from the DME (DME-3000/7000)
connected to these ports.
At this time, connect the DME input video signals and key signals as follows.
• DME1 video input: AUX1 output
• DME1 key input: AUX2 output
• DME2 video input: AUX4 output
• DME2 key input: AUX5 output
Note that for a DME external video signal, you can select any of AUX1 to
AUX14 on the DME. Connect to the selected AUX bus.

Making Switcher Processor GPI Input Settings

1
In the Switcher >Device Interface menu, press [GPI Input].
The GPI Input menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
1
2
3
In the <Trigger Type> group, select the trigger type.
pulse.
input signal.
high.
No Operation: Apply no trigger on an input pulse.
4
In the <Target> group, select the action block.
M/E-1, M/E-2, M/E-3, M/E-4, P/P: Set the action for one of the banks.
Parameter Adjustment
Port Port selection
No Selection of number for action to be
assigned
(Rising Edge): Apply the trigger on a rising edge of an input pulse.
(Falling Edge): Apply the trigger on a falling edge of an input
(Any Edge): Apply the trigger on a change in the polarity of the
(Level): Carry out the specified operation when the input is low or
Interfacing With External Devices (Device Interface Menu)
Setting values
1 to 8
1 to 8
1205