Sony MVS-8000X User Manual page 1239

Block
BLOCK 2
8
Press [Enter].
This confirms the settings.
9
Repeat steps 5 to 8 as required to set the constants for other VTRs.
Making detailed settings for a disk recorder (Sony disk 9-pin
protocol)
1
In the <DCU Select> group of the DCU >Serial Port Assign menu, select
the target for the setting (DCU1 or DCU2).
2
Using any of the following methods, select the serial port connected to the
disk recorder for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
a) The range of setting values depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
3
Press [Port Setting].
The DCU >Serial Port Assign >DDR SD9P Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, SCU number, and disk recorder type appear. In the lower
part of the status area, the response speed settings appear.
4
Using any of the following methods, specify the item to which the
response speed setting applies.
Byte Setting item
1 TC READ DELAY (FRAME)
2 START DELAY (FRAME)
3 AFTER SYNC DELAY–
4 AFTER SYNC DELAY+
5 MODE1
6 MODE2
7 MAX PRRL SPEED
8 QUICK PVW PRRL TIME (FRAME)
Parameter Adjustment
Port No Serial port
Setting values
1 and upwards
Serial Port Settings (Serial Port Assign Menu)
a)
1239