Maintaining Link Aggregation - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
Step 5 Run:
interface eth-trunk trunk-id.subnumber
An Eth-Trunk sub-interface is created.
subnumber specifies the number of a sub-interface. The value ranges from 1 to 4096.
Step 6 Run:
ip address ip-address { mask | mask-length } [ sub ]
An IP address is configured for the sub-interface.
When configuring multiple IP addresses for an Eth-Trunk sub-interface, use the sub keyword
to indicate the IP addresses configured after the first one.
----End

2.7 Maintaining Link Aggregation

This section describes how to maintain link aggregation, including monitoring the link
aggregation running status and clearing LACPDU statistics.
2.7.1 Clearing LACP Packet Statistics
Context
The cleared LACPDU statistics cannot be restored. Exercise caution when you run the reset
command.
Procedure
l
l
----End
2.7.2 Monitoring the LAG Operating
Context
During routine maintenance, run the following commands in any view to check the LAG
operating status.
Issue 01 (2014-11-30)
NOTICE
Run the reset lacp statistics eth-trunk [ trunk-id [ interface interface-type interface-
number ] ] command in the user view to clear statistics about LACPDUs received and sent.
Run the reset lacp error packet statistics command in the user view to clear statistics on
error LACPDUs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
57