Configuring Atom Vp Cell Mode Relay Support - Cisco ASR 1000 Series Software Configuration Manual

Configuring AToM VP Cell Mode Relay Support

PATH
AIS = 0
LOP = 1
Active Defects: None
Active Alarms:
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
ATM framing errors:
HCS (correctable):
HCS (uncorrectable): 0
APS
not configured
COAPS = 0
State: PSBF_state = False
Rx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 13
PATH TRACE BUFFER : STABLE
BER thresholds:
TCA thresholds:
Clock source:
Configuring AToM VP Cell Mode Relay Support
To configure Any Transport over MPLS (AToM) Cell Mode Relay, perform the following procedure beginning
in global configuration mode:
SUMMARY STEPS
1. Router(config)# interface atm slot/subslot/port.subinterface multipoint
2. Router(config-if)# no ip address ip-address mask
3. Router(config-if)# atm pvp vpi l2transport
4. Router(config-if)# xconnect peer-ip-address vc-id {encapsulation mpls | pw-class pw-class-name }
5. Router(config-if)# end
DETAILED STEPS
Command or Action
Step 1 Router(config)# interface atm
slot/subslot/port.subinterface multipoint
Step 2 Router(config-if)# no ip address ip-address mask
Step 3 Router(config-if)# atm pvp vpi l2transport
Step 4
Router(config-if)# xconnect peer-ip-address vc-id
{encapsulation mpls | pw-class pw-class-name }
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
82
RDI = 1 FEBE = 21
NEWPTR = 0 PSE
None
0
PSBF = 0
Tx(K1/K2): 00/00
SF = 10e-3 SD = 10e-6
B1 = 10e-6 B2 = 10e-6
line
Purpose
Enters interface configuration mode for the indicated port on
the specified ATM SPA
Removes the IP address that is assigned to this interface (if one
has been configured).
Creates a permanent virtual path (PVP) used to multiplex (or
bundle) one or more virtual circuits (VCs).
Routes Layer 2 packets over a specified point-to-point VC by
using ATM over multiprotocol label switching (AToM).
BIP(B3) = 0
= 0 NSE
B3 = 10e-6
Configuring the ATM SPAs
= 0
OL-14127-17