Schedule Period - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

schedule period

To configure the amount of time during which all LSP operations are scheduled to start or run, use the schedule
period command in IP SLA MPLS LSP monitor schedule configuration mode. To remove the scheduler, use
the no form of this command.
schedule period seconds
no schedule period
Syntax Description
seconds
Command Default
None
Command Modes
IP SLA MPLS LSP monitor schedule configuration
Command History
Release
Release 3.5.0
Usage Guidelines
Use the schedule period command to specify the amount of time in seconds during which all LSP operations
are scheduled to start running. All LSP operations are scheduled equally spaced throughout the schedule
period.
For example, if the schedule period is 600 seconds and there are 60 operations to be scheduled, they are
scheduled at 10-second intervals.
Use the frequency command to specify how often the entire set of operations is performed. The frequency
value must be greater than or equal to the schedule period.
You must configure the schedule period before you can start MPLS LSP monitoring. Start MPLS LSP
monitoring using the start-time command.
Task ID
Task ID
monitor
OL-24735-01
Amount of time in seconds for which label switched path (LSP) operations are
scheduled to run. Range is 1 to 604800.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
schedule period
217