Table of Contents
Advertisement
Chapter 3
Installing the Cisco ASR 901 10G Router
Note
Step 2
Configure the terminal or terminal emulation software for 9600 baud, 8 data bits, no parity, and 2 stop
bits.
Note
Connecting the Network Cables
This section describes how to connect the following router interfaces:
•
•
•
•
•
•
•
Connecting Gigabit Ethernet Interface Cables
The RJ-45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair
(UTP) cables. Cisco Systems does not supply Category 5 UTP cables; these cables are available
commercially.
Complete the following steps to connect the cable to the router Gigabit Ethernet port:
Ensure the router is powered off.
Step 1
Connect one end of the cable to the GE port on the router.
Step 2
Connect the other end to the BTS patch or demarcation panel at your site.
Step 3
For more information about Gigabit Ethernet connectors including pinouts, see
Connector Pinouts" section on page B-1
Connecting T1 and E1 Interface Cables
Complete the following steps to connect the cable to a router T1/E1 port:
Note
You must close the relays on the card using the standalone subcommand. For more information, see the
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide.
OL-28105-02
The RJ-45-to-DB-25 adapter (Cisco part number 29-0810-01) can be purchased from Cisco
Systems.
Hardware flow control is not possible on the console port.
Connecting Gigabit Ethernet Interface Cables, page 3-21
Connecting T1 and E1 Interface Cables, page 3-21
Connecting SFP Cables, page 3-22
Connecting Cables to the BITS Interface, page 3-22
Connecting GPS Cables, page 3-22
Connecting GPS Cables, page 3-22
Connecting to the Management Ethernet Port, page 3-23
Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
Connecting Cables
"Gigabit Ethernet
3-21
Advertisement
Table of Contents
Troubleshooting
