Default Lldp Configuration - Cisco Catalyst 2960 Software Configuration Manual

Chapter 26 Configuring LLDP, LLDP-MED, and Wired Location Service
If you change a location address on the switch, the switch sends an NMSP location notification message
that identifies the affected ports and the changed address information.
Configuring LLDP, LLDP-MED, and Wired Location Service
•
•
•
•
•
•
•

Default LLDP Configuration

Table 26-1
Feature
LLDP global state
LLDP holdtime (before discarding)
LLDP timer (packet update frequency)
LLDP reinitialization delay
LLDP tlv-select
LLDP interface state
LLDP receive
LLDP transmit
LLDP med-tlv-select
Configuration Guidelines
•
•
•
•
•
OL-26520-01
Default LLDP Configuration, page 26-5
Configuration Guidelines, page 26-5
Enabling LLDP, page 26-6
Configuring LLDP Characteristics, page 26-6
Configuring LLDP-MED TLVs, page 26-7
Configuring Network-Policy TLV, page 26-8
Configuring Location TLV and Wired Location Service, page 26-9
Default LLDP Configuration
If the interface is configured as a tunnel port, LLDP is automatically disabled.
If you first configure a network-policy profile on an interface, you cannot apply the switchport
voice vlan command on the interface. If the switchport voice vlan vlan-id is already configured on
an interface, you can apply a network-policy profile on the interface. This way the interface has the
voice or voice-signaling VLAN network-policy profile applied on the interface.
You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
You cannot configure a network-policy profile on a private-VLAN port.
For wired location to function, you must first enter the ip device tracking global configuration
command.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring LLDP, LLDP-MED, and Wired Location Service
Default Setting
Disabled
120 seconds
30 seconds
2 seconds
Disabled to send and receive all TLVs
Disabled
Disabled
Disabled
Disabled to send all LLDP-MED TLVs. When
LLDP is globally enabled, LLDP-MED-TLV is
also enabled.
26-5