1. Error Messages
6.35 : Expression value error
[ 9] Memory errors
9.1
: Program destroyed
9.2
: Point data destroyed
9.3
: Memory destroyed
9.4
: Parameter destroyed
9.5
: Illegal object code
10
9.6
: Shift data destroyed
9.7
: Hand data destroyed
24
10-
Code
: &H0623
Meaning/Cause : The expression value is other than -1 and 0 even though condi-
tional expression is a numeric expression.
Action
: 1. Set the expression value correctly.
2. Change the "TRUE condition" parameter setting.
Code
: &H0901
Meaning/Cause : a. Part or all of the program data has been destroyed
b. This error message is sometimes issued due to a major error
Action
: 1. Delete that program during selection.
2. Initialize the program data.
Code
: &H0902
Meaning/Cause : a. Part or all of the point data has been destroyed
b. This error message is sometimes issued due to a major error
Action
: Initialize the point data.
Code
: &H0903
Meaning/Cause : Error or malfunction occurred in the memory.
Action
: Initialize memory.
Code
: &H0904
Meaning/Cause : Part or all of the parameter data has been destroyed.
Action
: Initialize the parameter data.
Code
: &H0905
Meaning/Cause : An object program has been destroyed.
Action
: Compile and make an object program.
Code
: &H0906
Meaning/Cause : Part or all of the shift data has been destroyed.
Action
: Initialize the shift data.
Code
: &H0907
Meaning/Cause : Part or all of the hand data has been destroyed.
Action
: Initialize the hand data.
or the power being turned off during rewrite of program data.
or the power being turned off during rewrite of point data.