System Setting Or Hardware Errors - Yamaha RCX142 User Manual

4-axis robot controller
Table of Contents

Advertisement

1. Error Messages
9.38 : Sequence object memory full
9.39 : Sequence object destroyed
9.40 : Cannot found sequence object
9.41 : Local variable memory full

[10] System setting or hardware errors

10.1 : Robot disconnected
10.3 : D.unit disconnected
10
10.6 : DRIVER.unit version mismatch
10.7 : CPU.unit version mismatch
26
10-
Code
: &H0926
Meaning/Cause : Sequence object program exceeded its memory capacity.
Action
: Compress the source size of sequence program, so that the
object program size is reduced.
Code
: &H0927
Meaning/Cause : Part or all of the sequence object program has been destroyed.
Action
: Make the sequence object program again.
Code
: &H0928
Meaning/Cause : No sequence object program.
Action
: Make the sequence object program.
Code
: &H0929
Meaning/Cause : Number of local variables defined within subroutine has ex-
ceeded upper limit.
Action
: 1. Reduce number of local variables defined in the subroutine.
2. Use the global variable.
Code
: &H0A01
Meaning/Cause : Axis control was attempted with "no axis" specified for all axes
of system generation.
Action
: Re-perform the system generation.
Code
: &H0A03
Meaning/Cause : Manual movement was attempted on the axis that is not speci-
fied.
Action
: Do not perform any axis-related operation.
Code
: &H0A06
Meaning/Cause : Driver unit version does not match the CPU unit.
Action
: Make sure the CPU unit and driver unit versions match each
other.
Code
: &H0A07
Meaning/Cause : CPU unit version does not match the CPU.
Action
: Make sure the CPU unit and driver unit versions match each
other.

Advertisement

Table of Contents
loading

Table of Contents