Toshiba e-STUDIO 2555C Service Manual page 1446

Sub
05/08 Mode Element
element
08 Setting System General
Mode
08 Setting System Maintenan
Mode ce
08 Setting System Maintenan Notification of
Mode ce remaining amount of
toner
08 Setting System Maintenan Notification of
Mode ce remaining amount of
toner
08 Setting System Maintenan Notification of
Mode ce remaining amount of
toner
08 Setting System User Display setting
Mode interface
08 Setting System User Card reading device
Mode interface
08 Setting System General
Mode
08 Setting System Maintenan Display of remaining
Mode ce amount of toner (for
RDMS/MMDT)
Item Subitem Code
8750
8752
8755
8756
8756
LED head/Main 8757
charger
8758
8761
8762
Sub- Default Acceptable
Details
code value value
Time to wait for print 0 0-1
image
Switchover of display 0 0-1
of notice on the
control panel when
the time to replace the
unit has come
Enable/Disable setting 0 0-1
0 Remaining amount at 25 0-100
first notification
1 Notification interval 10 1-25
Cleaning button 2 0-2
Overwriting of login at 0 0-1
authentication
Retention of print 0 0-1
(spooling) data
0 K 0 0-100
209
RAM Contents
SYS Sets whether the drum idling is executed or not when
the waiting for print image occurred. If there is the stain
on the back side of the paper, set the value of this code
to "1". When the value is set to "1", the number of times
the equipment stops printing may increase.
0: Waiting is enabled (8 sec.)
1: Waiting is disabled (0 sec.)
SYS Specifies the contents of the message displayed on the
control panel when the time to replace the unit has
come.
0: Contact the service engineer for replacement (SRU)
1: Replacement by user (CRU)
SYS 0: Disabled
1: Enabled
SYS 0 to 100%
SYS 1 to 25%
SYS 0: Not displayed
1: Displayed (USER FUNCTIONS -> USER)
2: Displayed (USER FUNCTIONS -> ADMIN)
SYS Switches the enable/disable setting for the function to
overwrite the login information at the card
authentication.
0: Disabled
1: Enabled
SYS Use this code to retain and obtain the print data
(spooling data) if problem occurs. After obtaining the
data, be sure to disable the setting.
0: Disabled (print data is deleted)
1: Enabled (print data is retained)
SYS 0～100%
Proce Servic
dure e UI
1
1 Yes
1 Yes
4 Yes
4 Yes
1 Yes
1 Yes
1 Yes
14