Detaching And Refitting The Developer Drive Unit - Olivetti d-Copia 3500MF Service Manual

(2) Detaching and refitting the developer drive unit

Procedure
1. Remove the rear upper cover and the
rear lower cover (see page 1-5-52).
2. Remove the connector.
3. Release the wire saddle.
4. Remove two screws and then remove
the developer drive unit.
5. Check or replace the developer drive
unit and refit all the removed parts.
Service Manual
Developer drive unit
Screws
Connector
1-5-58
Wire saddle
Figure 1-5-97
2LL/2LJ/2LH
Y113350-5