Table of Contents
Advertisement
Item No.
U147
Setting for toner applying operation
Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying
operation).
Purpose
Changing settings are not required. However, when the documents with lower print density (e.g.
less than 2%) should customarily printed in a great volume, mode must be changed.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the start key.
2. Select the item to be set.
Timing
Mode
Upper Limit
Minimum
Setting: [Upper Limit]
1. Change the setting value using the +/- keys or numeric keys.
Display
Paper Int
Job End
2. Press the start key. The value is set.
Setting: [Mode]
1. Select the mode.
Mode0
Mode1
Mode2
Initial setting; Mode1
2. Press the start key. The setting is set.
Service Manual
Display
Setting timing to transit to toner applying
Settings for toner applying operation
Upper limit printing ratio of toner applying quantity with each mode
Toner layer width when cleaning mode is selected
Description
Setting number of pages to transit
to toner applying (between pages)
Setting number of pages to transit
to toner applying (job completed)
Display
Less consumption of toner than a regular toner applying operation
Executes toner applying with the regular amount of toner
More consumption of toner than a regular toner applying operation
Description
Description
Setting
range
0 to 100
0 to 100
Description
1-3-86
2LL/2LJ/2LH
Initial setting
35ppm 45ppm 55ppm
4
4
4
35
45
55
Y113350-5
Advertisement
Table of Contents
