Table of Contents
Advertisement
29. Pass the connector of the key counter
wire through the aperture in the right
upper cover.
30. Refit the right upper cover.
31. Refit the ISU right cover.
32. Close the paper conveying unit.
33. Connect the key counter signal cable to
the key counter wire.
34. Fit the key counter cover to the
machine using the M4 x 6 screw.
35. Insert the key counter into the key
counter socket assembly.
36. Turn the main power switch on and
enter the maintenance mode.
37. Run maintenance item U204 and select
[Key-Counter] (see page 1-3-97).
38. Exit the maintenance mode.
39. Check that the message requesting the
key counter to be inserted is displayed
on the touch panel when the key coun-
ter is pulled out.
40. Check that the counter counts up as
copies are made.
Service Manual
Right upper cover
Key counter wire
Key counter
wire
Key counter
signal cable
1-2-26
Aperture
Key counter wire
Figure 1-2-34
Key counter
cover
Figure 1-2-35
2LL/2LJ/2LH
M4 x 6 screw
Y113350-5
Advertisement
Table of Contents
