Olivetti d-Copia 3500MF Service Manual page 205

Item No.
U411 7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Method: [DP FaceDown (Chart1)]
To manually enter the target value
1. Enter the target values which are shown on the specified original (P/N: AVGR14938B) execut-
ing maintenance item U425. Set a specified original (P/N: AVGR14938B) on the DP face
down.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [U425] and press the start key.
5. Select [DP FaceDown (Chart1)].
6. Select [All].
To manually enter the target value
1. Set a specified original (P/N: AVGR14938B) on the DP face down.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [Auto] and press the start key.
5. Select [DP FaceDown (Chart1)].
6. Select [All].
All
7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Y113350-5
Display
Executing the adjustment in the DP scanning section (second
side) for magnification, leading edge timing, center line, MTF
filter, input gamma and matrix
Description
Description
1-3-143
2LL/2LJ/2LH
Sevice Manual