Olivetti d-Copia 3500MF Service Manual page 36

Unlocking the developer waste exit
Caution
To ease setup, the device was shipped
with the developer unit already replenished
with developer. Therefore, to prevent
developer from spilling during shipping, a
developer shutter is equipped with the
developer unit.
To disengage the shutter, use the following
procedure: Note that if the shutter is not
completely disengaged and retained in
place, the developer in the developer unit
may clog at the outlet causing a damage to
the developer unit.
1. Press the fixing pin and rotate.
*: Fully insert the fixing pin with keeping the
protrusions vertical and rotate it by 90
degrees clockwise. Make sure that the
protrusions are then horizontal.
2. Remove a screw and slide the lever
right wards.
3. Fix the lever using the screw previously
removed at the right screw hole and
unlock the developer waste exit.
*: When the device is shipped again or
removed, use the reverse procedure to
lock in the developer waste exit. Failure
to observe this caution could result in
deteriorated print quality and/or C call
(7460).
Service Manual
[Locked]
1
Fixing pin
Protrusions
Figure 1-2-16
[Locked]
2
Lever
1
Screw
Figure 1-2-17
1-2-12
2LL/2LJ/2LH
[Released]
2
Fixing pin
Protrusions
[Released]
Lever
Screw
3
Y113350-5