Table of Contents
Advertisement
Item No.
U411
To manually enter the target value
1. Set a specified original (P/N: AVGR14938B) on the platen.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [Auto] and press the start key.
5. Select [Table (Chart1)].
6. Select the item.
All
LED/AGC
White
Input
C.A.
MTF
Gamma
Matrix
7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Method: [DP FaceUp (Chart1)]
To manually enter the target value
1. Enter the target values which are shown on the specified original (P/N: AVGR14938B) execut-
ing maintenance item U425. Set a specified original (P/N: AVGR14938B) on the DP face up.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [U425] and press the start key.
5. Select [DP FaceUp (Chart1)].
6. Select [Input].
To manually enter the target value
1. Set a specified original (P/N: AVGR14938B) on the DP face up.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [Auto] and press the start key.
5. Select [DP FaceUp (Chart1)].
6. Select [Input].
Input
Service Manual
Display
Executing the all scanner adjustment
Executing the adjustment for LED light quantity/AGC
Executing the white reference compensation coefficient
Executing the adjustment for magnification, leading edge tim-
ing and center line
Executing the adjustment for chromatic aberration filter
Executing the adjustment for MTF filter
Executing the adjustment for input gamma
Executing the adjustment for matrix
Display
Executing the adjustment in the DP scanning section (first
side) for magnification, leading edge timing and center line
Description
Description
Description
1-3-142
2LL/2LJ/2LH
Y113350-5
Advertisement
Table of Contents
