Detaching And Refitting The Eject Unit - Olivetti d-Copia 3500MF Service Manual

(5) Detaching and refitting the eject unit

Procedure
1. Remove the right upper cover (see
page 1-5-53).
2. Remove the fuser unit (see page 1-5-
36).
3. Remove the connector.
4. Remove two screws and then remove
the eject unit.
5. Check or replace the eject unit and refit
all the removed parts.
Cautions on installing the eject unit
When inserting the eject unit into the device,
use care that the eject unit does not get in con-
tact with the eject guide, by keeping its actua-
tor lifted while inserting.
Y113350-5
Connector
Screw
Figure 1-5-116
Actuator
Figure 1-5-117
1-5-71
2LL/2LJ/2LH
Eject unit
Eject guide
Sevice Manual
Screw