Table of Contents
Advertisement
Item No.
U340
Setting the applied mode
Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a
working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct print-
ing occurs.
Method
1. Press the start key.
2. Select the item to set.
Adj Memory
Adj Max Job
Setting: [Adj Memory]
1. Change the setting using the +/- keys or numeric keys.
Image
Image(Detail)
Set the values below in case print failure occurs with the memory shortage.
(recommended value)
Image : +190
Image(Detaile) : +1
2. Press the start key. The value is set.
3. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Supplement
The work area for copy is small and it may cause output failure if the values are large.
Setting: [Adj Max Job]
1. Change the setting using the +/-keys or numeric keys.
Copy
Printer
The maximum Printer jobs should be (maximum jobs) – (maximum copy jobs).
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Service Manual
Display
Setting the memory allocation
Setting the maximum of multiple jobs
Display
Area temporarily used to create output
image.
Area temporarily used to hold down-
loaded font and other data.
Display
Maximum copy (Scan To Print) Jobs
Maximum printer (Host To Print) Jobs
Description
Description
Description
Description
1-3-132
2LL/2LJ/2LH
Setting
Initial
range
setting
0 to 400 (MB) 0
0 to 400 (MB) 0
Setting
Initial
range
setting
10 to 50
10
10 to 50
-
Y113350-5
Advertisement
Table of Contents
