Configuring Auto Archive; Claiming Media - EMC DL3D 1500 Administrator's Manual

Configuring and Managing Virtual Tape Libraries

Configuring Auto Archive

Claiming media

82 EMC DL3D 1500 and DL3D 3000 Administrator's Guide
You can configure attached physical libraries using the Auto Archive
page. Once configured, the libraries are recognized and available to
the DL3D system for data backups.
CAUTION
!
The DL3D cannot support a physical tape library with mixed media
in a single partition.
Note: You must enable the Auto Archive license to configure the physical
libraries. See "License keys" on page 172
license keys.
The Auto Archive page is divided into the following sections:
Media
Behaviors
Devices
To configure Auto Archive:
1. Discover attached physical devices. See
devices" on page
2. Claim media. See
3. Set Import/Export behavior. See
of media" on page
4. Set up early tape creation. See
on page 85.
5. Configure barcode filters. See
page 86.
Use the Claim Media page to assign media options to unknown
media, as follows:
1. To access the Media page, click Auto Archive on the PTT page.
2. On the Media page, click Claim Media. The Claim Media page
appears.
3. Select the cartridges from the unknown media list.
for information on uploading the
77. Change the intended use to Auto Archive.
"Claiming media" on page
"Setting import/export behavior
84.
"Configuring early tape creation"
"Configuring barcode filters" on
"Discovering physical
82.