Analyzer - EMC DL3D 1500 Administrator's Manual

Analyzer

Network analysis
The Analyzer page allows you to analyze both the network
information as well as the disk information.
To access the Analyzer page:
1. Access the Utilities page.
contains more information.
2. Click Analyzer.
The Analyzer page is divided into the following sections:
Network Analysis
Disk Analysis
Network analysis measures the network performance with another
system. The system that is specified below in the IP Address section
should have NetServer enabled.
The Network page is divided into the following sections:
Performance
Settings
Performance
The Performance section is used to perform network analysis with
another system:
1. Type the IP address of another system in the IP address box.
2. Click Start to begin the analysis.
The throughput result is displayed in MB/sec.
Settings
The network performance monitor will test the network performance
between the DL3D appliance and your network. You must have a
network performance client installed on a local host to use this
functionality.
To enable/disable netserver:
1. Click Settings.
2. Select enable or disable and click Apply.
"Accessing utilities" on page 166
Accessing utilities
Managing Utilities
167