Community - EMC DL3D 1500 Administrator's Manual

Table 2

Community

!
SNMP trap selections (continued)
Field Description
Failure Generates a trap on system-detected errors.
Available Generates a trap every time the library transitions from an
unavailable to an available state.
Unavailable Generates a trap every time the library transitions from an available
to an unavailable state.
5. Click Apply to save the destination information.
Note: Appendix A lists warning and failure events.
Use the Community page to add, edit, and delete the SNMP
community information.
1. Click Add in the Community area.
2. In Add SNMP Community, type the new community
information:
• A unique name in the Name field; the field holds up to 20
characters (a-z, A-Z) with no special characters or blank
spaces.
CAUTION
If no communities are defined, the DL3D appliance is
universally accessible through a "public" community (read
only).
• IP address in the IP Address field; if the value in the Network
Mask edit box ends in a zero, the value in the IP address edit
box must also end in a zero.
Note: An IP address of 0.0.0.0 will disable the IP address access
control for the community. Similarly, a zero in the octet of the IP
address (and corresponding network mask octet) will allow access
for the entire range of addresses in that part of the IP address. If not
disabled, the source address of an SNMP request is logically ANDed
Configuring DL3D 1500/3000
Configuring SNMP 49