Virtual Tape Library Commands; List Vtl; List Library - EMC DL3D 1500 Administrator's Manual

Command Line Interface

Virtual tape library commands

list vtl

Description

list library

Description
176 EMC DL3D 1500 and DL3D 3000 Administrator's Guide
This section lists the virtual tape library commands in the DL3D
1500/3000 command line interface and the syntax and output of
these commands.
Lists all existing virtual tape libraries and their attributes
The list vtl command lists all the existing virtual tape libraries
available if you do not specify the name of any virtual tape library. If
you specify a virtual tape library, only that virtual tape library is
listed with its attributes. Attributes include the name of the virtual
tape library, mode, library model, drive model type, number of
drives, number of media, number of slots, serial number,
de-duplication status (enabled/disabled), and backup window status
(enabled/disabled). If the backup window status is enabled for the
virtual tape library, the list will also include the start and end time of
the backup window.
Syntax syscli --list vtl [--name <vtl name>]
Output
vtl count=1
vtl=1
name = myvtl
mode = offline
model = DL1500
drivemodel = QUANTUMDLTS4
drives = 2
media = 2
slots = 12
serial = 123456XYZ
dedup = enabled
backupwindow = disabled
Lists all available virtual tape library models
The list library command lists the available virtual tape library
models. The specific library model or product ID is required while
adding or creating a new virtual tape library.