Did Translation Number Conversion - NEC univerge SV9100 Programming Manual

Level:
SA
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for each Translation
Table entry (4000).
The digits received by the system (eight maximum)

The extension the system dials after translation (24 digits maximum)

The name that should show on the dialed extension display when it rings (12 characters maximum)

The Transfer Target – 2 and 3

If the Transfer Targets are busy or receive no answer, those calls are transferred to the
final transfer destination (Program 22-10).
NOTE
Operation Mode

Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
Table 2-9 Keys for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12
digits.
Use this keypad digit . . . When you want to. . .
1
2
3
4
5
6
7
2-374
Program 22 : Incoming Call Setup

22-11 : DID Translation Number Conversion

Key for Entering Names
Enter characters:
 
1 @ [¥] ^ _ ` {|}
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Á À Â Ã Ç É Ê ì ó
Program 22 : Incoming Call Setup
Issue 4.0