Trunk Access Code - NEC univerge SV9100 Programming Manual

Issue 4.0
Level:
IN
Description
Use
Program 11-09 : Trunk Access Code
code can be set from 1~8 digits which is defined to type 3 and 4 in Program 11-01. This is the code
extension users dial to access Automatic Route Selection. The individual Trunk Access Code is used
when Trunk Group Routing is desired for an outgoing line.
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you must
CAUTION
make the corresponding changes in Program 11-01.
Input Data
Item Trunk Access
No. Code
01
Dial
(Up to four digits)
02
2nd Trunk Route
Access Code
Conditions
None
SV9100 Programming Manual
Program 11 : System Numbering
to assign the trunk access code (normally 9). The trunk access
Description
Assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
Define additional trunk
access codes.
When a user dials the
Alternate Trunk Route
Access Code, the system
routes their call to the
Alternate Trunk Route.

11-09 : Trunk Access Code

Default Related Program
9 11-01 : System Numbering

14-01 : Basic Trunk Data Setup

14-05 : Trunk Group

14-06 : Trunk Group Routing

21-02: Trunk Group Routing for

Extensions
No
11-01 : System Numbering

Setting
14-01 : Basic Trunk Data Setup

14-05 : Trunk Group

14-06 : Trunk Group Routing

21-02 : Trunk Group Routing for

Extensions
21-15 : Individual Trunk Group

Routing for Extensions
2-111