NEC univerge SV9100 Programming Manual page 871

Issue 4.0
Alarm
Type Report
No.
57 2 0 IP Collision
Error
58 2 0 Failure of
Outbound IP
Connection
59 --- Reserved ---
60 2 0 SIP
Registration
Error
Notification.
SV9100 Programming Manual
Name Content of Alarm
Collision(01) indicates the
address programmed in
10-12-01 has been
duplicated. Collision (02)
indicates the address
programmed in 10-12-09
has been duplicated.
Collision(03) ~
Collision(10) indicates the
addresses programmed in
84-26-01 have been
duplicated. (03) is GW1 ~
(10) is GW8.
01: Programming session
is already active.
02: Not setting of IP
Address or Port.
03: Caller ID does not
match.
10: Cannot get IP Address.
11: Socket Open Error.
12: Socket Port Setting
Error.
13: TCP Session Timeout.
1.The registration of the
SIP trunk to the SIP
server failed.
2.The registration of the
SIP trunk to the SIP
server failed in the
authentication.
3.There is no response
from the SIP server to
the SIP registration
request.
Cause Action
An IP address Confirm that the
programmed in addresses assigned in
either 10-12-01, 10- 10-12-01, 10-12-09,
12-09 or 84-26 is and 86-26 are not
duplicated duplicated anywhere
somewhere on the else on the network.
same segment of
the network. The
system will check
every 5 minutes
and is not a
programmable
increment.
1. The system data 1. Confirm the following
setting is wrong. system data setting --
PRG 10-12, 10-28,
10-29, 10-30, and 10-
2. The router
36.
setting is wrong.
2.Confirm the setting of
3. LAN link error.
routers.
4. Net side trouble.
3.Confirm whether
abnormality occurs
on the net side.
4. Confirm the
authentication
system data setting.
5. Confirm wiring and
the system data
setting. Inquire on
uncertain points of
the maker.
Alarm
Recovery
Status
The error is ERR
recovered
when normally
REC
connecting it.
2-831